PPG INDUSTRIES -- DXR80 DELTHANE ULTRA  -- 8010-00F006031
<pre>=====================  Product Identification  =====================

Product ID:DXR80 DELTHANE ULTRA
MSDS Date:07/27/1990
FSC:8010
NIIN:00F006031
MSDS Number: BVRHR
=== Responsible Party ===
Company Name:PPG INDUSTRIES
Address:4325 ROSANNA DR
Box:9
City:ALLISON PARK
State:PA
ZIP:15101-5000
Country:US
Info Phone Num:412-492-5555/304-843-1300
Emergency Phone Num:304-843-1300/412-492-5555
CAGE:PPGIN
=== Contractor Identification ===
Company Name:PPG INDUSTRIES
Address:4325 ROSANNA DR
City:ALLISON PARK
State:PA
ZIP:15101-5000
Country:US
Phone:412-492-5555/304-843-1300
CAGE:PPGIN

=============  Composition/Information on Ingredients  =============

Ingred Name:ALIPHATIC POLYISOCYANATE, HEXAMETHYLENE DIISOCYANATE
    POLYMER (HDI POLYMER)
CAS:28182-81-2
RTECS #:NQ9170000
Fraction by Wt: 80-85%
Other REC Limits:1 MG/CUM

Ingred Name:PROPYLENEGLYCOL MONOMETHYL ETHER ACETATE,
    1-METHOXY-2-PROPANOL ACETATE
CAS:108-65-6
RTECS #:AI8925000
Fraction by Wt: 15-20%

Ingred Name:HEXAMETHYLENE DIISOCYANATE
CAS:822-06-0
RTECS #:MO1740000
Fraction by Wt: 1-2%
ACGIH TLV:0.005 PPM
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:INGESTION: HARMFUL/FATAL. EYES: SEVERE
    IRRITATION. SKIN: PRIMARY IRRITATION/ALLERGIC REACTION. HARMFUL IF
    ABSORBED. INHALATION: VAPOR/SPRAY MIST HARMFUL. MAY CAUSE
    IRRITATION/ALLERGIC RESPIRATORY REAC TION IN LUNGS, PERMANENT
    BRAIN/NERVOUS SYSTEM DAMAGE.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, ASTHMA LIKE SYMPTOMS, CHEST
    TIGHTNESS, WHEEZING, SHORTESS OF BREATH, COUGHING, WATERING,
    HEADACHES, NAUSEA, DIZZINESS, LOSS OF COORDINATION, ITCHING,
    BURNING SENSATION, VISUAL DISTURBANCES , DRYNESS, CRACKING,
    SWELLING.
Medical Cond Aggravated by Exposure:CHRONIC/LONG TERM LUNG/BREATHING
    PROBLEM, PRIOR REACTION TO ISOCYANATES.

=======================  First Aid Measures  =======================

First Aid:INGESTION: GIVE 1-2 GLASS OF WATER. DON'T INDUCE VOMITING.
    EYES: FLUSH IMMEDIATELY W/PLENTY OF WATER FOR 15 MINS. SKIN: FLUSH
    IMMEDIATELY W/PLENTY OF WATER FOLLOWED BY WASHING W/SOAP & WATER.
    INHALATI ON: REMOVE TO FRESH AIR. APPLY CPR/OTHER SUPPORTIVE
    MEASURES AS NEEDED. OBTAIN MEDICAL ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:105F
Extinguishing Media:CO2, DRY CHEMICAL, UNIVERSAL AQUEOUS FILM FORMING
    FOAM.
Fire Fighting Procedures:WEAR SCBA. WATER SPRAY MAY BE INEFFECTIVE BUT
    MAY BE USED TO COOL CLOSED CONTAINERS. IF WATER IS USED, FOG
    NOZZLES ARE PREFERRABLE.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE WHEN
    EXPOSED TO EXTREME HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:PROVIDE MAXIMUM VENTILATION. EVACUATE AREA.
    REMOVE ALL IGNITION SOURCES. TAKE UP MATERIAL W/SAWDUST,
    VERMICULITE/OTHER ABSORBENT MATERIAL & PLACE INTO CONTAINERS FOR
    DISPOSAL.

======================	Handling and Storage  ======================

Handling and Storage Precautions:DON'T STORE >120F. KEEP CONTAINERS
    TIGHTLY CLOSED. ISOLATE FROM HEAT, ELECTRICAL EQUIPMENT, SPARKS,
    OPEN FLAMES. DON'T APPLY TO HOT SURFACES.
Other Precautions:GROUND CONTAINERS WHEN POURING. AVOID FREE FALL OF
    LIQUIDS >A FEW INCHES. IF MATERIAL IS PART OF A MULTIPLE COMPONENT
    COATING SYSTEM READ MSDS FOR OTHER COMPONENT(S) BEFORE BLENDING AS
    RESULTING MIXTU RE MAY HAVE HAZARDS OF ALL ITS PARTS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:WEAR A NIOSH/MSHA APPROVED POSITIVE PRESSURE AIR
    SUPPLIED RESPIRATOR WHERE OVERSPRAY IS PRESENT & UNTIL ALL
    VAPORS/MISTS ARE GONE.
Ventilation:GENERAL DILUTION/LOCAL EXHAUST IN VOLUME & PATTERN TO KEEP
    CONCENTRATION OF CONTAMINANTS <LOWEST SUGGESTED TLV.
Protective Gloves:NITRILE/NEOPRENE/LATEX RUBBER
Eye Protection:CHEMICAL SPLASH GOGGLES/FULL FACE SHIELD
Other Protective Equipment:NITRILE/NEOPRENE/LATEX RUBBER PROTECTIVE
    CLOTHING.
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING & SHOES
    BEFORE REUSE.
Supplemental Safety and Health
INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING/INHALAING CONTENTS CAN
    BE HARMFUL/FATAL.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:293F
Vapor Pres:3.7
Vapor Density:>1
Spec Gravity:1.09
Evaporation Rate &amp; Reference:(BU O AC =100): 35
Solubility in Water:2.9%
Appearance and Odor:VISCOUS LIQUID W/CHARACTERISTIC SOLVENT ODOR
Percent Volatiles by Volume:17

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG ALKALIES/MINERAL ACIDS/OXIDIZING AGENTS, WATER & ALCOHOLS.
Stability Condition to Avoid:EXTREME HEAT, HEAT, ELECTRICAL EQUIPMENT,
    SPARKS, OPEN FLAMES,
Hazardous Decomposition Products:CO, OXIDES OF NITROGEN, HEXAMETHYLENE
    DIISOCYANATE, HYDROGEN CYANIDE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:EMPTY CONTAINERS SHOULD BE RECYCLED/DISPOSED OF
    THROUGH AN APPROVED WASTE MANAGEMENT FACILITY IAW/FEDERAL, STATE,
    PROVINCIAL & LOCAL ENVIRONMENTAL CONTROL REGULATIONS.   UN1283

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.