JDM MAINTENANCE -- 211SV CONCRETE SEALER CLEAR  -- 8030-00N025750
<pre>=====================  Product Identification  =====================

Product ID:211SV CONCRETE SEALER CLEAR
MSDS Date:05/01/1990
FSC:8030
NIIN:00N025750
MSDS Number: BMPTT
=== Responsible Party ===
Company Name:JDM MAINTENANCE
Box:379
City:COMMACK
State:NY
ZIP:11725
Country:US
Info Phone Num:516-499-0623
Emergency Phone Num:516-499-0623
CAGE:JDMMA
=== Contractor Identification ===
Company Name:JDM MAINTENANCE CORP
Box:379
City:COMMACK
State:NY
ZIP:11725
Country:US
Phone:414-354-6417
CAGE:JDMMA

=============  Composition/Information on Ingredients  =============

Ingred Name:BENZIN; (AROMATIC NAPHTHA). VP: 4.
CAS:8030-30-6
RTECS #:DE3030000
Fraction by Wt: 40-80%
ACGIH TLV:100 PPM (MFR)

Ingred Name:PARAFFIN WAXES & HYDROCARBON WAXES, CHLORINATED;
    (CHLORINATED PARAFFIN)
CAS:63449-39-8
RTECS #:RV0450000
Fraction by Wt: 1-8%

Ingred Name:SUPP DATA: REMAINING LIQ MAY BE TAKEN UP ON
    SAND/CLAY/EARTH/FLOOR ABSORBENT &/OR ABSORBENT MATL & SHOVELED INTO
    CONTRS.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:YES	 OSHA:NO
Health Hazards Acute and Chronic:EYES: CAN CAUSE SEVERE IRRIT, REDNESS,
    TEARING, BLURRED VISION. SKIN: CAN CAUSE MODERATE IRRIT, DEFAT,
    DERMAT. INHAL: CAN CAUSE NAUSEA/HEADACHE, POSSIBLE UNCON, & EVEN
    ASPHYXIATION. INGEST: CAN CAUSE  GI IRRIT, NAUS, VOMIT & DIARR.
    ASPIRATION OF MATL INTO THE LUNGS CAN CAUSE CHEM PNEUMOCONIOSIS
    WHICH CAN BE FATAL.
Explanation of Carcinogenicity:CHLOROPARAFFIN WAXES & HYDROCARBON
    WAXES: IARC GRP 2B.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:EYES: FLUSH W/LARGE AMTS OF WATER, LIFTING UPPER/LOWER LIDS
    OCCASIONALLY. CONSULT MD. SKIN: THOROUGHLY WASH EXPOSED AREA W/SOAP
    & WATER. REMOVE & LAUNDER CONTAMD CLTHG BEFORE RE-USE. INHAL:
    REMOVE TO  FRESH AIR. IF BRTHG HAS STOPPED, GIVE ARTF RESP. KEEP
    WARM/QUIET & CONSULT MD. INGEST: DO NOT INDUCE VOMITING, KEEP
    WARM/QUIET AND CONSULT MD.

=====================  Fire Fighting Measures  =====================

Flash Point:110F,43C
Lower Limits:1%
Extinguishing Media:REGULAR FOAM, CARBON DIOXIDE OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED POSITIVE PRESSURE
    SCBA AND FULL PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:VAPS ARE HVR/AIR & MAY TRAVEL ALONG
    GROUND OR MAY BE MOVED BY VENT & IGNITED BY PILOT LIGHTS/OTHER
    FLAMES/SPARKS/HEATERS/SMKG/ELEC MOTORS &/OR OTHER (SUPP DATA)

==================  Accidental Release Measures  ==================

Spill Release Procedures:SML SPILL: ABSORB LIQUID ON PAPER/VERMICULITE/
    FLOOR ABSORB &/OR OTHER ABSORB MATL & TRANSFER TO VENTILATED
    CLOSURE. LGE SPILL: ELIM ALL IGNIT SOURCES (FLAMES/PILOT
    LIGHTS/ELEC SOURCES/ETC). PERSONS N OT WEARING PROT EQUIP SHLD BE
    EXCLUDED (SUPP DATA)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:CONTRS OF THIS MATL MAY BE HAZ WHEN
    EMPTIED. SINCE EMPTIED CONTRS RETAIN PROD RESIDUES (VAPS/LIQ &/OR
    SOLID), ALL HAZ PREC GIVEN MUST BE OBSERVED.
Other Precautions:KEEP OUT OF REACH OF CHILDREN.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF TLV OF PRODUCT IS EXCEEDED, A NIOSH/MSHA
    JOINTLY APPROVED SCBA W/A FULL FACE PIECE OPERATED IN POSITIVE
    PRESSURE MODE OR OTHER NIOSH/MSHA APPROVED RESPIRATORS UNDER
    SPECIFIED CONDITIONS.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL) &/OR LOCAL EXHAUST
    VENTILATION TO MAINTAIN EXPOSURE BELOW TLV'S.
Protective Gloves:WEAR RESISTANT GLOVES LIKE BUNA-N.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
    CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:LAUNDER CONTAMINATED CLOTHING BEFORE RE-USE.
Supplemental Safety and Health
EXPLO HAZ: IGNIT SOURCES AT LOCATIONS DISTANT FROM MATL HNDLG POINT.
    NEVER USE WELDING/CUTTING TORCH ON OR NEAR DRUM (EVEN EMPTY)
    BECAUSE PROD (EVEN JUST RESIDUE) CAN IGNITE EXPLOSIVELY. SPILL
    PROC: F ROM AREA OF SPILL. STOP SPILL AT SOURCE, DIKE AREA OF SPILL
    TO PVNT SPREADING, PUMP LIQUID TO SALVAGE TANK. (ING 3)

==================  Physical/Chemical Properties  ==================

HCC:F4
Boiling Pt:B.P. Text:>323F,>162C
Vapor Pres:SEE ING 1
Vapor Density:HVR/AIR
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:53-82

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT W/STRONG OXIDIZING AGENTS (E.G. NITRIC ACID,
    PERMANGANATES, ETC.).
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY FORM TOXIC MATERIALS - CARBON
    DIOXIDE & CARBON MONOXIDE, HYDROGEN CHLORIDE, STYRENE AND ACRYLATE
    MONOMERS, ETC.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF I/A/W LOCAL, STATE AND FEDERAL
    REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.