SEAGRAVE COATINGS CORP -- CONVERTER-EPOXY CONVERTER, F-8502  -- 8010-00N020985
<pre>=====================  Product Identification  =====================

Product ID:CONVERTER-EPOXY CONVERTER, F-8502
MSDS Date:08/14/1991
FSC:8010
NIIN:00N020985
MSDS Number: BLJCG
=== Responsible Party ===
Company Name:SEAGRAVE COATINGS CORP
Address:320 PATERSON PLANK RD
City:CARLSTADT
State:NJ
ZIP:07072
Country:US
Info Phone Num:201-933-1000
Emergency Phone Num:800-424-9300 (CHEMTREC)
Preparer's Name:AN
CAGE:DO631
=== Contractor Identification ===
Company Name:SEAGRAVE COATINGS CORP OF VA.
Address:4030 SEAGUARD AVENUE
City:PORTSMOUTH
State:VA
ZIP:23701
Phone:1-800-424-9300
CAGE:DO631
Company Name:SEAGRAVE CORP TITANINE DIVISION
Address:320 PATERSON PLANK RD
Box:City:CARLSTADT
State:NJ
ZIP:07072-2302
Country:US
CAGE:78767

=============  Composition/Information on Ingredients  =============

Ingred Name:XYLENES (O-,M-,P- ISOMERS)	(SARA III)
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: <10%
OSHA PEL:100 PPM/150 STEL
ACGIH TLV:100 PPM/150STEL;9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:METHYL CHLOROFORM (1,1,1-TRICHLOROEHANE)  (SARA III)
CAS:71-55-6
RTECS #:KJ2975000
Fraction by Wt: <75%
OSHA PEL:350 PPM/450 STEL
ACGIH TLV:350 PPM/450STEL;9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Ozone Depleting Chemical:1

Ingred Name:ETHYL BENZENE  (SARA III)
CAS:100-41-4
RTECS #:DA0700000
Fraction by Wt: <5%
OSHA PEL:100 PPM/125 STEL
ACGIH TLV:100 PPM/125STEL 9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:EPOXY RESIN HARDENER (MIXTURE)
Fraction by Wt: <20%

Ingred Name:SUPP DATA: FORMATION OF HCL &/OR PHOSGENE . THIS PROD
    CONTAINS ONE OR MORE MATLS SUBJECT TO THE REPORTING (ING 6)
RTECS #:9999999ZZ

Ingred Name:ING 5: REQS OF SEC 313 OF THE EMERGENCY PLANNING & THE
    COMMUNITY RIGHT-TO-KNOW ACTS OF 1986 & OF 40 CFR 372.
RTECS #:9999999ZZ

Ingred Name:RESP PROT: UNLESS AIR MONITORING RECORDS VAPOR/MIST LEVELS
    BELOW APPLICABLE LIMITS.
RTECS #:9999999ZZ

Ingred Name:VENT: TLV LIMIT. USE ONLY WITH ADEQUATE VENTILATION.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:BRTHG OF HIGH VAP CONCS MAY PRDCE
    NARCOSIS. LIQUID MAY CAUSE MINOR SKIN IRRIT & DEFINITE EYE IRRIT.
    CAUSES NOSE & THROAT IRRIT. CAUSES EYE/SKIN IRRIT. RPTD/PRLNG
    OVEREXPOSURE TO SOLVENTS COULD CAUSE P ERM BRAIN & NERVOUS SYSTEM
    DAMAGE. INTENTIONAL MISUSE BY DELIB CONCENTRATING & INHALING
    CONTENTS MAY (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: BE HARMFUL/FATAL. CHLOROCARBON MATLS
    HAVE PRDCED SENSIT OF THE MYOCARDIUM TO EPINEPHRINE IN LAB ANIMALS
    & MAY HAVE A SIMILAR EFFECT IN HUMANS. ADRENOMIMETICS (E.G.,
    EPINEPHRINE) MAY BE CONTR AINDICATED EXCEPT FOR LIFE-SUSTAINING
    USES IN HUMANS ACUTELY OR CHRONICALLY EXPOSED TO CHLOROCARBONS .
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:INHAL: REMOVE TO FRESH AIR, RESTORE BREATHING. CONSULT MD.
    SKIN: WASH THOROUGHLY W/SOAP & WATER. EYE: FLUSH IMMEDIATELY
    W/PLENTY OF WATER FOR A MINIMUM OF 15 MIN & GET IMMEDIATE MEDICAL
    ATTENTION. ING EST: GET MEDICAL ATTENTION IMMEDIATELY.

=====================  Fire Fighting Measures  =====================

Flash Point Method:SCC
Flash Point:70.0F,21.1C
Lower Limits:1%
Upper Limits:15%
Extinguishing Media:DRY CHEMICAL, CO2, FOAM, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED PRESSURE DEMAND SCBA
    & FULL PROTECTIVE EQUIPMENT . WATER MAY BE USED TO COOL CONTRS. IF
    WATER IS USED, FOG NOZZLES ARE PREFERRED.
Unusual Fire/Explosion Hazard:KEEP CONTRS TIGHTLY CLOSED. VAPS MAY
    MIGRATE TO IGNIT SOURCE & CAUSE FLASH FIRE. ISOLATE FROM
    HEAT/SPARKS/ELEC EQUIP/ APPLIANCES/PILOT LIGHTS/FLAMES (SUPP DATA)

==================  Accidental Release Measures  ==================

Spill Release Procedures:IN CASE OF SPILLAGE, ABSORB WITH INERT
    MATERIAL & DISPOSE OF I/A/W APPLICABLE REGULATIONS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE AWAY FROM HEAT, SPARKS & OPEN
    FLAME. AVOID PRLNG SKIN CONT. DO NOT BREATHE SPRAY MIST. STORE IN A
    COOL DRY AREA W/VENT SUITABLE FOR (SUPP DATA)
Other Precautions:GROUND CONTRS WHILE POURING. AVOID SPONT COMBUST OF
    CONTAM RAGS OR OTHER ORGANIC MATLS. EMPTY CONTRS MAY RETAIN HAZ
    PROPERTIES & CAN BE DANGEROUS. NO SMKNG IN AREA OF USE. DO NOT USE
    IN THE GEN VICIN  OF ARC WELDING, OPEN FLAMES (SUPP DATA)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NIOSH/MSHA APPRVD RESP TYPES SUITABLE FOR MATLS
    IN INGREDS RECOM. NIOSH/MSHA APPRVD CHEM/MECH FILTERS RECOM WHEN
    VENT IS RESTRICTED. DO NOT BREATH (DUST/VAPS/SPRAY MIST). WEAR
    APPROP NIOSH/MSHA APPRVD  RESP DURING/AFTER APPLICATN (ING 7)
Ventilation:SUFFICIENT VENT, IN VOL/PATTERN, SHLD BE PROVIDED TO KEEP
    AIR CONTAM BELOW CURRENT APPLIC OSHA PEL OR ACGIH'S (ING 8)
Protective Gloves:CHEMICAL RESISTANT PLASTIC OR RUBBER.
Eye Protection:CHEM WORK GOG & FULL LENGTH FSHLD.
Other Protective Equipment:AS REQUIRED TO AVOID WETTING CLOTHING. USE
    PROTECTIVE CREAMS WHERE SKIN CONT IS LIKELY. EYE BATH/SAFETY
    SHOWER.
Work Hygienic Practices:WASH CONTAM CLOTHING BEFORE REUSE. AVOID CONT
    W/ EYE/SKIN & CLTHG. WASH THOROUGHLY AFTER HANDLING.
Supplemental Safety and Health
% VOLAT: 81.3(WT); 77.2(VOLUME). EXPLO HAZ: & OTHER SOURCES OF IGNIT.
    FLAMM LIQUID/VAP. THERMAL DECOMP PRODS MAY INCLUDE HCL & PHOSGENE .
    MATLS TO AVOID: ALUMINUM & ZINC POWDERS SHLD BE AVOIDED. 
    HNDLG/STOR PREC: STORING MATLS SHOWN IN INGREDS. OTHER PREC: OR HOT
    SURFACES. HEAT &/OR UV RADIA MAY CAUSE THE (ING 5)

==================  Physical/Chemical Properties  ==================

HCC:F5
Boiling Pt:B.P. Text:165F,74C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Appearance and Odor:LIQUID WITH CHARACTERISTIC ODOR.
Percent Volatiles by Volume:SUPDAT

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS. ALUMINUM IS NOT ACCEPTABLE FOR PUMPS, MIXERS,
    FITTINGS, STORAGE TANKS. METALLIC (SUPP DATA)
Stability Condition to Avoid:EXCESSIVE HEAT, SPARKS, OR OPEN FLAME.
Hazardous Decomposition Products:HCL, PHOSGENE .

====================  Disposal Considerations  ====================

Waste Disposal Methods:PLACE IN CLOSED CONTAINERS. DISPOSE OF PRODUCT
    I/ A/W LOCAL, COUNTY, STATE, AND FEDERAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.