DRYDEN OIL COMPANY -- 10W30 TEC II TURBO MOTOR OIL  -- 9150-00-256-6411
<pre>=====================  Product Identification  =====================

Product ID:10W30 TEC II TURBO MOTOR OIL
MSDS Date:01/14/1988
FSC:9150
NIIN:00-256-6411
MSDS Number: BKHKG
=== Responsible Party ===
Company Name:DRYDEN OIL COMPANY
Address:9300 PULASKI HWY
City:BALTIMORE
State:MD
ZIP:21220
Info Phone Num:(301) 574-5000
Emergency Phone Num:(301) 574-5000
CAGE:40310
=== Contractor Identification ===
Company Name:DRYDEN OIL CO INC
Address:9300 PULASKI HWY
Box:City:BALTIMORE
State:MD
ZIP:21220
Country:US
Phone:301-574-5000
CAGE:40310
Company Name:WARD'S AUTO PARTS, INC.
CAGE:WARDS

=============  Composition/Information on Ingredients  =============

Ingred Name:SOLVENT REFINED HYDROTREATED HEAVY PARAFFINIC DISTILLATE,
    HYDROTREATED HEAVY PARAFFINIC DISTILLATE, LUBRICATING OIL.
CAS:64742-54-7
RTECS #:PY8035500
Fraction by Wt: <80%
OSHA PEL:5 MG/CUM (MIST)

Ingred Name:MINERAL OIL, PETROLEUM DISTILLATES, SOLVENT-REFINED HEAVY
    PARAFFINIC, LUBRICATING OIL BASE STOCK
CAS:64741-88-4
RTECS #:PY8040500
Fraction by Wt: <80%
OSHA PEL:5 MG/CUM
ACGIH TLV:5 MG/CUM

Ingred Name:PROPRIETARY ADDITIVES
Fraction by Wt: <20%

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:EYES/SKIN: IRRITATION. INGESTION:
    RELATIVELY NON-TOXIC. INHALATION: IRRITATION IF OVERCOME BY VAPOR
    FROM HOT PRODUCT.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:SKIN/EYES: IRRITATION. INGESTION: RELATIVELY
    NON-TOXIC. INHALATION: IRRITATION IF OVERCOME BY VAPOR FROM HOT
    PRODUCT.

=======================  First Aid Measures  =======================

First Aid:EYES: FLUSH W/PLENTY OF WATER FOR AT LEAST 15 MINS. SKIN:
    WASH W/SOAP & WATER. INHALATION: REMOVE TO FRESH AIR. GIVE CPR OR
    OXYGEN IF NEEDED. IF OVER-EXPOSED TO OIL MIST, REMOVE FROM FURTHER
    EXPOSURE  UNTIL EXCESSIVE MIST OIL CONDITION SUBSIDES. INGESTION:
    DON'T INDUCE VOMITING. OBTAIN MEDICAL ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point Method:COC
Flash Point:390-433F
Lower Limits: 0.9%
Upper Limits: 7%
Extinguishing Media:FOAM, WATER SPRAY (FOG), DRY CHEMICAL, CO2,
    VAPORIZING LIQUID TYPE EXTINGUISHING AGENTS.
Fire Fighting Procedures:USE WATER SPRAY, DRY CHEMICAL, FOAM/CO2. USE
    WATER TO KEEP FIRE-EXPOSED CONTAINERS COOL. USE SUPPLIED AIR
    BREATHING EQUIPMENT FOR ENCLOSED/CONFINED AREAS.
Unusual Fire/Explosion Hazard:IF SPILL HAS NOT IGNITED, USE WATER SPRAY
    TO DISPERSE VAPORS. DON'T PRESSURIZE/CUT/WELD/BRAZE/SOLDER OR
    EXPOSE CONTAINERS TO IGNITION SOURCES, THEY MAY EXPLODE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:RECOVER FREE PRODUCT. ADD SAND, EARTH OR OTHER
    SUITABLE ABSORBENT MATERIAL TO SPILL. OPEN ALL WINDOWS & DOORS.
    AVOID BREATHING VAPORS. KEEP PRODUCT OUT OF SEWERS & WATERCOURSES
    BY DIKING OR IMPOUNDING .

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP STORAGE CONTAINERS CLOSED WHEN
    NOT IN USE. DON'T STORE NEAR HEAT/SPARKS/FLAME/STRONG OXIDANTS.
    DON'T ATTEMPT TO REMOVE RESIDUE FROM CONTAINERS.
Other Precautions:EMPTY CONTAINERS RETAIN RESIDUE (LIQUID/VAPOR) & CAN
    BE DANGEROUS. DON'T PRESSURIZE, CUT, WELD, BRAZE, SOLDER, DRILL,
    GRIND, OR EXPOSE CONTAINERS TO SOURCES OF IGNITION. THEY MAY
    EXPLODE & CAUSE INJUR Y/DEATH. AVOID SKIN & EYE CONTACT.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NO SPECIAL REQUIREMENTS UNDER ORDINARY
    CONDITIONS OF USE & W/ADEQUATE VENTILATION. USE AS NEEDED.
Ventilation:PROVIDE ADEQUATE VENTILATION TO KEEP <TLV.
Protective Gloves:CHEMICAL RESISTANT
Eye Protection:SPLASH GOGGLES, FACE SHIELD
Other Protective Equipment:AS NEEDED
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
    REUSE. DISCARD OIL-SOAKED SHOES. WASH THOROUGHLY BEFORE BREAKS,
    MEALS, ETC.
Supplemental Safety and Health
EMPTY DRUMS SHOULD BE COMPLETELY DRAINED, PROPERLY BUNGED & PROMPTLY
    RETURNED TO A DRUM RECONDITIONER.

==================  Physical/Chemical Properties  ==================

Vapor Pres:NEGLIGIBLE
Vapor Density:>AIR
Spec Gravity:0.8940-0.8899
Evaporation Rate &amp; Reference:NEGLIGIBLE
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR, DARK AMBER LIQUID W/MILD, BLAND PETROLEUM
    ODOR
Percent Volatiles by Volume:NEGL

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
OXIDIZING MATERIALS
Stability Condition to Avoid:HEAT, OPEN FLAMES, SPARKS, PILOT LIGHTS,
    STATIC ELECTRICITY, SOURCES OF IGNITION
Hazardous Decomposition Products:CO/UNIDENTIFIED ORGANIC CMPS/COMPLEX
    MIX OF AIRBORNE SOLID/LIQUID/PARTICULATES/GASES/FUMES/SMOKE/SULFUR
    OXIDE/ALDEHYDES

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE W/LOCAL, STATE, &
    FEDERAL REGULATIONS. ADVISE AUTHORITIES IF THE PRODUCT HAS ENTERED
    OR MAY ENTER SEWERS, WATERCOURSES, OR EXTENSIVE LAND AREAS. DON'T
    PRESSURIZE CONTAINERS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.